Third-party Management Tools

You can install third-party management tools on ztC Edge systems. Examples of such tools include vendor-specific management/monitoring utilities, enterprise management/monitoring utilities, and other miscellaneous management/monitoring software. Note the following:

In general, management tools that run on the host operating system (CentOS) should run on ztC Edge systems. Possible exceptions are tools that manage/monitor the CentOS KVM-based virtualization. To manage/monitor ztC Edge virtualization, use the integrated ztC Edge management tools.
Before deploying your ztC Edge system, Stratus recommends that you verify that it operates properly with the management tools installed and operational.
Stratus recommends that you set up a non-root account for third-party management tools.
You can access your ztC Edge system via the management network using the IP address(es) specified during the installation process (or supplied by the DHCP server if the interface was configured for DHCP during install).
If you install third-party management tools in the host operating system of a physical machine (PM) and you need to replace the PM in the future, remember to reinstall the tools on the replacement PM.

Note: Third-party management tools have the potential of destabilizing the environment of the host operating system and system software. You may need to remove management tools that consume excessive RAM or disk space, or that are otherwise suspected of destabilizing the product. Follow the recommendation of your authorized Stratus service representative.

Product Support and Downloads ztC Edge Support ztC Edge Downloads Phone: (US Toll-Free) 866-763-1813 Phone: (International) 602-852-3094	About Stratus U.S. Operations 5 Mill and Main Place Suite 500 Maynard, MA 01754-2660 978-461-7000 Worldwide Office Locations Contact Stratus
Product Documentation (PDF Format) ztC Edge User's Guide ztC Edge 100i/110i Systems: Deploying a Dual-Node System (R012Z) ztC Edge 100i/110i Systems: Replacing a Node (R013Z) ztC Edge 100i/110i Systems: Deploying a Single-Node System (R014Z) ztC Edge 100i/110i Systems: Adding a Node (R015Z)	About Help Help created at 10:28 PM on 4/29/2021.