Space Recommendations

To ensure that the installation site for a ztC Edge 100i or 110i system provides a properly equipped, cooled, and sized environment, consider the following space recommendations for your site.

Space recommendations for nodes located on a table follow:

• At least 2 in. (5.08 cm) of space on the left and right sides of a node
• At least 3 in. (7.62 cm) of space on the top of a node
• At least 5 in. (12.7 cm) of space on the front and rear of a node
• At least 2 in. (5.08 cm) of space between nodes

Space recommendations for DIN rail-mounted nodes follow:

• At least 2 in. (5.08 cm) of space on the left and right sides of a node
• At least 5 in. (12.7 cm) of space on the top and bottom of a node
• At least 2 in. (5.08 cm) of space between nodes

Additional space recommendations follow:

• A node can be installed either horizontally (on a flat surface) or vertically (on a wall). If it is installed vertically, the surface with the Stratus logo should be facing up.

• To prevent damaging the system’s cables, the bend radius for all cables should be at least 2 in. (5.08 cm).

• Avoid installing any kind of heat-generating source below the node.

• Avoid exceeding the operational environmental limits of the node.

• Each node should have at least 100 LFM (0.51 m/s) of airflow over the heatsink for optimal heat transfer.

In addition to the preceding recommendations, evaluate your site's specific installation needs. If you need further guidance, contact your authorized Stratus service representative.

of

Product Support and Downloads ztC Edge Support ztC Edge Downloads Phone: (US Toll-Free) 866-763-1813 Phone: (International) 602-852-3094	About Stratus U.S. Operations 5 Mill and Main Place Suite 500 Maynard, MA 01754-2660 978-461-7000 Worldwide Office Locations Contact Stratus
Product Documentation (PDF Format) ztC Edge User's Guide ztC Edge 100i/110i Systems: Deploying a Dual-Node System (R012Z) ztC Edge 100i/110i Systems: Replacing a Node (R013Z) ztC Edge 100i/110i Systems: Deploying a Single-Node System (R014Z) ztC Edge 100i/110i Systems: Adding a Node (R015Z)	About Help Help created at 10:28 PM on 4/29/2021.